Mods
8ft steel diamond plate flatbed \r
1/4” decking, very heavy bed\r
Dually converted but still 3/4 ton\r
1994 Chevy 454 swap\r
LS6 heads\r
MSD Pro billet distributor \r
Edelbrock Performer intake manifold \r
Edelbrock 750 carb \r
Headers to dynomax exhaust\r
Soon to get different intake and Holley double pumper
1/4” decking, very heavy bed\r
Dually converted but still 3/4 ton\r
1994 Chevy 454 swap\r
LS6 heads\r
MSD Pro billet distributor \r
Edelbrock Performer intake manifold \r
Edelbrock 750 carb \r
Headers to dynomax exhaust\r
Soon to get different intake and Holley double pumper
Build story
The motor swap was done 15 years ago by my dad and some of his cousins, and once that was all done it has stayed at our house and we use it to plow snow. I am 14, and I am planning on buying this from my dad for my first vehicle. It came from down south, so there is little rust. I am going to sandblast and bed liner the flat bed and then get the cab repainted. I can not say I did the motor swap because when it was done I was very young if even born at the time. I have fun with it and I plow snow with it at our house. It does run and drive but the plates are expired and it is not going to go back under insurance until I can drive.